Product Descriptionit is a two component epoxy based paint which can be applied to concrete, metal, wood, plaster and gypsum surface and is resistant to severe service conditions and chemicals. in order to obtain textured surface, Teknobond 600 TIX should be used.
Areas of Usage
• lndoor and outdoor places,
• Constantly wet areas, the areas that chemical agents are used
• in food factories.
• in laboratories, used on the materials such as parquet, floor tile, tile, ceramic, mosaic, glass mosaic,and porcelain.
• Also suitable forwalls, ceilings and floor coverings/upholstery
Features and Benefits
• Water impermeable.
• Resistant to chemicals and bacteria
• Resistant to freeze
• Long-lasting
• Hygienic, easy to clean
Application lnstructions
Surface Quality:The surfaces should be clean, dry, strong and free from all foreign objects which may cause separation.
Surface Preparation: The roughness on the surface should be levelled, and the hollow shapes should be filled.
Compound: TEKNOBOND 600 is a two component product. The proportionally prepared components A and B which consists of hardener agent and resin, are mixed together by using a low speed mixer. The mixing is continued until a homogenous mixture is obtained.
Application Notes / Restrictions
• in self application, special filling is added and poured as necessary it is levelled by trowel and combed with spiked roller.
• in order to complete the hardening of the material, do not use it allowed minimum temperature. Low temperatures will slow down the hardening, while high temperatures will accelerate the hardening. The pot life will alsa vary depending on the temperatures.
• The product may irritate the skin. Protective glasses or gloves should be used. Protective hand cream should be used before starting work. lf the soil mixture comes into contact with eyes, eyes should be washed immediately with warm water and you should go to doctor.
• Crystallization can be shown in the product if it is kept below 0°C fora long time. lf the crystals are broken by bringing the product back to room temperature, the product can be used without any problem. Discoloration and yellowing can be happened in the product which hardened depending on direct sunlight. After application , the product should be protected against direct sunlight, strong wind, high air temperature (above +35 °C), bad weather conditions such as rain and freeze. in order to complete the hardening and reaction shortly after the application, the areas that contacts with skin should be cleaned with water and detergent.
• lmmediately after application , the equipment should be cleaned with Tekno Thinner before it becomes hard.
