Construction Reinforcement Products

  TDS Technical Document Sheet   

Product Description
Epoxy impregnated, glass fiber rod, cured in unidirectional form.

Areas of Usage
• in slabs, bridges where the carrying capacity is to be increased,
• With the column strengthened,
• in the sagged upholstery,
• On beams and balconies,
• in bridges with load increments,
• lf there is a lack of facilities,
• it is used in case of cutting of floor and damage of the building elements

Features and Benefits
• it is very light, it does not increasethe section if it is too thin.
• Very high strength.
• The modulus of elasticity is too high.
• The chemical resistance is excellent.
• lts application is easy and fast, few workmanship mistakes.
• it has excellent fatigue strength.

Application lnstructions
Surface Ouality: Concrete should be strong and have sufficient strength.

Surface Preparation: Floor must be cleaned, oil, dirt, dust, water, moisture should not remain. Weak concrete parts should be repaired and restored with high strength repair mortar.

Application lnstructions: TEKNOBOND 400 is mixed proportionally. it is applied asa thin layer to the concrete and Teknobar to be bonded to the bar. The bar is glued by cleaning dust, oil and dirt. The material works only in the direction of the fiber length. No liability will be accepted for faults that occur during the application.

Application Notes / Restrictions
• it is an easyto apply material. Thetin plate orspiral can be cut tothe desired size. Static
• it is recommended to use it afterthe project is done.
• The material only works in the fiber length direction. There is no resistance side by side.
• The product may irritate the skin. Work clothes, protective gloves, masks and glasses must be used. Hand washing cream can be applied before starting work . in case of grout contact with eyes, eyes should be washed immediately with warm water and consult a doctor.
• Crystallization can be observed in the product if it remains long below 0°C. lf the crystals are dissolved by bringing the product back to room temperature, it can be used without any problems .
• Do not add any foreign material into the product.
• Before the application, the design of the reinforcement project must be done by a civil engineer. it must be projected and held accountable.
• The application should be made by experienced and competent persons.