CATEGORIES
SHEETS CAN DOWNLOAD HERE TSE DOCUMENT
DID YOU SEE? CE DOCUMENT
DID YOU SEE? OUR CATALOG YOU CAN
DOWNLOAD AS PDF
- Tile Adhesives and Joint Fillers Fuga
- Repair Mortars and Grouts
- Thermal Insulation Products
- Industrial Flooring Products
- Granito Microbeton
- Tekno Stone Carpet
- Restoration Products
- Waterproofing Products
- Concrete Admixtures
- Construction Reinforcement Products
- Construction Chemicals General List
SHEETS CAN DOWNLOAD HERE TSE DOCUMENT
DID YOU SEE? CE DOCUMENT
DID YOU SEE? OUR CATALOG YOU CAN
DOWNLOAD AS PDF
Teknobond 400 D Dilatation Adhesive
Overhead and adhesion of PVC, TPE dilatation membranes to dilatation for horizontal applications is a two component, high strength epoxy material used in the thixotropic consistency, adhesion and repair work specially developed for the epoxy resin.
TDS Technical Document Sheet
CE Document
Overhead and adhesion of PVC, TPE dilatation membranes to dilatation for horizontal applications is a two component, high strength epoxy material used in the thixotropic consistency, adhesion and repair work specially developed for the epoxy resin.
Areas of Usage
• in bonding the dilatation tapes to the concrete,
• AII kinds of concrete, marble, stone materials such as repair, glued,
• it is used for adhering materials such as tiles, granites to polished surfaces.
Features and Benefits
• lts application is a very easy material.
• Water and gas are impermeable.
• it is resistant to chemicals and abrasion.
• it provides excellent adhesion for concrete.
• it will not retract.
Application lnstructions
Surface Quality: The surface of the application should be free from all kinds of dust, dirt, weak and volatile particles, cement grout residues, oil and dirt and be dry. Concrete bottom surface should be clean, strong and have sufficient compressive strength (at least 25 N/mm2) , its pull-off strength should be at least 1.5 N/mm2.
Surface Preparation: A masking band is placed on both sides of the dilatation to ensure that the dilatation band is properly removed and that the epoxy does not spread around.
Mixing: After component B has been added to component A, stir for 2-3 minutes until a homogeneous color is obtained with a low speed, electric stirrer (up to 400 rpm).
TEKNOBOND 400 D epoxy is applied as minimum 5 cm to the right and left sides of the dilatation band. it is then glued onto the dilation band. it is seen that the epoxy comes out of the band holes. The next day, the second layer is applied on the band as slightly overflow on the edges. it is advisable to make an inverted or flat omega (Q) in the middle of the dilation so that the band does not consume its elasticity immediately.
Application Notes / Restrictions
• Do not apply ifthetemperature is below +5°C.
• Solvent-free, cannot be thinned with thinner.
• When mixing and applying, use rubber gloves and work gloves to protect your skin and eyes from exposure. Especially eyes should be carefully protected.
• lf it contacts with eyes, rinse your eyes with plenty of water for about 15 minutes and immediately contact a doctor.
• Do not add anyforeign material, water into the product.
• in extreme hot weather, the mixture should be prepared as consumed because the product will harden immediatelywhen mixed.
• The material spilled around and contaminated with application equipment can be cleaned with Tekno Clean Thinner.