Construction Reinforcement Products

  TDS Technical Document Sheet   

Description of Product
The product is a two component, hydraulic lime and synthetic resin based, polymer reinforced, and UV resistant waterproofing material with perfectly elastic application property.

Fields of Application
• it is used in isolation of historical masonry structures,
• lsolation of external plastering applications,
• lsolation of plaster and surface repair.

Features and Benefits
• Used in isolation of historical structures since it does not contain soluable salts.
• Applied with a brush or roller, or applied by spraying.
• Cement free.
• Does not shrink or crack.
• Suitable tor both vertical and horizontal applications.

Application Procedure
Surface Quality: The surface must be clean, smooth, solid and free from all kind of substances that prevent adhesion such as dust, oil, dirt, rust, detergent, ete. it there is a segregation in concrete, the damaged and slack pieces should be thrown and weak pieces should be removed. it cracks and holes exist on application surface or wall, they should be repaired by using a suitable TEKNOREP 510 repair mortar. TEKNOMER 500 should be applied 3-4 days later.

Surface Preparation: it the application surface is dry, it should be wetted and saturated with water betore the application. Sharp corners and edges should be chamfered with TEKNOREP 51O repair mortar.

Application Notes / Restrictions
• Do not inhale the dust and prevent from contact with skin and eye since the material is hydraulic lime based. Do not apply on wood, chipboard, mdf, plywood, PVC and metal surfaces.
• The mixture should be prepared by using the product's own liquid. Do not add any water in mixture.
• Do not add foreign substances.
The product need protection in order to obtain expected long-term performance. The necessary precautions should be taken against breakdown, scratch and impact after the application.
• Firstly, the liquid B component of TEKNOMER 500 is poured into a clean vessel which is free from any kind of material that prevent adhesion. Then, the powder A component of TEKNOMER 500 is added slowly to the vessel. The mixture is stirred with a low-speed stirrer until a homogeneous blend without lumps is obtained. The mixing time should be minimum 5 minutes. The mortar obtained at the end of this process should be rested tor 3 minutes, and mixed again tor 2 minutes until it became homogeneous. After the application, it must be protected from the bad weather conditions such as direct sunlight, strong wind, high temperature {above +35°C), rain and frost. The hands should be cleaned thoroughly with water and detergent before the product is fully cured and hardened.
• After the application, the equipment should be cleaned immediately with water betore the product is hardened.
• lf the product is hardened, the equipment should be cleaned by mechanical methods. TEKNOMER 500 is applied on the waterlogged surface with a brush or roll after completely mixed and rested, and it should be applied betore losing its humidity. After first setting of the material, the second layer is applied as perpendicular to the first layer. Fiber reintorcement can be used between layers if required.
• The necessary waiting period between layers; the next layer can be applied when no residue remains on hands upon touching the applied layer.