CATEGORIES
SHEETS CAN DOWNLOAD HERE TSE DOCUMENT
DID YOU SEE? CE DOCUMENT
DID YOU SEE? OUR CATALOG YOU CAN
DOWNLOAD AS PDF
- Tile Adhesives and Joint Fillers Fuga
- Repair Mortars and Grouts
- Thermal Insulation Products
- Industrial Flooring Products
- Granito Microbeton
- Tekno Stone Carpet
- Restoration Products
- Waterproofing Products
- Concrete Admixtures
- Construction Reinforcement Products
- Construction Chemicals General List
SHEETS CAN DOWNLOAD HERE TSE DOCUMENT
DID YOU SEE? CE DOCUMENT
DID YOU SEE? OUR CATALOG YOU CAN
DOWNLOAD AS PDF
Teknobond 350 Epoxy Casting Resin
Water clear casting epoxy resin with two component, low viscosity
TDS Technical Document Sheet
CE Document
Water clear casting epoxy resin with two component, low viscosity
Areas of Usage
• Can be used asa priming coat on epoxyfloorcoverings.
• Water sealing, filling concrete and cracks
• it is used in electricity and souvenir sector asa casting resin
Features and Benefits
• it is clear and therefore can be applied to many surfaces asa priming coat orfinishing coat
• TEKNOBOND 350 can also be used in lamination works.
Application lnstructions
Surface Quality: The loose particles on the surface are removed. Dirt, oil, rust are cleaned. ltisensuredthat the surface humidity is less than 4% relative humidity.
Surface Preparation: The holes are filled by putting sand into the TEKNOBOND 350 sufficiently and the damaged surfaces are repaired. After 6 hours , TEKNOBOND 350 is applied in one direction firstly and then in other direction by roller.
Surface and Environment Temperature: +5°C - +30°C
Compound: The proportionally prepared components A and B are mixed with a low- speed mixer, the mixing application is continued until homogenous consistency is obtained. TEKNOBOND 350 set can be used in small quantities considering the mixture proportion.
Application Method /Equipment: it is used with bristle brush, roller, spraying machines or manual. Consumption: in theory, depending on the surface condition and concrete quality, it is 0,300-0,500 kg/m 2. Except for sand put into the epoxy.
Cleaning: After application , the product should be protected against direct sunlight, strong wind, high airtemperature (above +35 °C). in order to complete the hardening and reaction shortly after the application, the areas that contacts with skin should be cleaned with water and detergent.
Equipment Cleaning: lmmediately after application, the equipment should be cleaned with Tekno Thinner before it becomes hard.
Pot Life: At 20°C temperature approximately 30 minutes
Cleaning Duration: At 20°C temperature approximately 45 minutes
Application Notes / Restrictions
• in order to complete the hardening of the material, do not use it allowed minimum temperature. Low temperatures will slow down the hardening, while high temperatures will accelerate the hardening. The pot life will also vary depending on the temperature.
• The product may irritate the skin. Protective glasses or gloves should be used. Protective hand cream should be used before starting work. lf the soil mixture contacts with eyes, eyes should be washed immediately with warm water, and consult doctor.
• Crystallization can be shown in the product if it is kept below 0°C fora long time. lf the crystals are broken by bringing the product back to room temperature, the product can be used without any problem.
• Discoloration and yellowing can be happened in the product which hardened depending on direct sunlight