CATEGORIES
SHEETS CAN DOWNLOAD HERE TSE DOCUMENT
DID YOU SEE? CE DOCUMENT
DID YOU SEE? OUR CATALOG YOU CAN
DOWNLOAD AS PDF
- Tile Adhesives and Joint Fillers Fuga
- Repair Mortars and Grouts
- Thermal Insulation Products
- Industrial Flooring Products
- Granito Microbeton
- Tekno Stone Carpet
- Restoration Products
- Waterproofing Products
- Concrete Admixtures
- Construction Reinforcement Products
- Construction Chemicals General List
SHEETS CAN DOWNLOAD HERE TSE DOCUMENT
DID YOU SEE? CE DOCUMENT
DID YOU SEE? OUR CATALOG YOU CAN
DOWNLOAD AS PDF
Teknobond 500 P Polyurethane Floor
Polyurethane Floor
TDS Technical Document Sheet
CE Document
Hygienic, two component polyurethane based floor covering material with solvent-free, self-levelling, high elastic and mechanical strength.
Areas of Usage
• Factories, cold storage depot, warehouses, refrigerated vehicle bodies.
• On EPDM plate in shopping centers, workshops, air plane sheds, schools, indoor sports facilities, and hospitals, pharmaceutical industry, food sector, laboratories,
• Can be applied in parking areas and the areas with heavy forklift traffic
Features and Benefits
• Abrasion and friction resistant,
• Elastic structure
• Creates ajoint less surface
• Easy to clean, hygienic, does not require long maintenance,
• Easy applicable,
• Solvent-free.
Application lnstructions
Surface Quality: Weak areas of the surfaces should be cleaned sandpaper, milling cutter and sand blasting. lf the surface is too bright, it should be roughened by milling cutter or sandblasting and the specific surface should be cleaned. lfthere is oil on the surface, it should be burned.
Surface Preparation: Cleaned surfaces should be applied an undercoat with TEKNOBOND 300. Teknobond 500 P application is made at the latest 24 hours after the priming coat application. Teknobond 500 P should be applied with trowel to obtain a smooth surface. Afterthen, gas bubbles are removed with a spikedroller.
Compound: After the component B is added to the component A, mix for 2-3 minutes with a low speed, electrical mixer (maximum 400 revolution per minute) until a homogenous color is obtained.
Application Notes / Restrictions
• Make sure that TEKNOBOND 500 P covers a continuous, non-porous surface. lf necessa ry, apply TEKNOBOND 300 priming coat application twice. TEKNOBOND 500 P is applied with notched trowel.
• in order to complete the hardening of the material, do not use it allowed minimum temperature. Low temperatures will slow down the hardening, while high temperatures will accelerate the hardening. The pot life will also vary depending on the temperature.
• The product may irritate the skin. Protective glasses or gloves should be used. Protective hand cream should be used before starting work . lf the soil mixture contacts with eyes, eyes should be washed immediately with warm water, and consult doctor.
• Crystallization can be shown in the product if it is kept below 0°C fora long time. lf the crystals are broken by bringing the product back to room temperature, the product can be used without any problem. Discoloration and yellowing can be happened in the product which hardened depending on direct sunlight. After application, the product should be protected against direct sunlight, strong wind, high airtemperature (above +35 °C), bad weather conditions such as rain and freeze. in order to complete the hardening and reaction shortly after the application, the areas that contacts with skin should be cleaned with water and detergent.
• lmmediately afterthe application, equipment should be cleaned with TeknoThinner.