Industrial Flooring Products

  TDS Technical Document Sheet   

  CE Document   

Product Description
Resistant to wear and dust, ready to use, gray colored, decorative wall stamping product.

Areas of Usage
• lndoor and outdoor,
• Areas requiring aesthetic concrete application,
• Shopping malls and fairgrounds,
• Artificial waterfall, rock, ete. manufacturing,
• On old plasterorwall, brick, stone or readyto use panels

Features and Benefits
• Virtually all surfaces can be applied smoothly
• Highly natural images are obtained by advanced coloring techniques
• Light, isolation specifically and breathable product
• Plastic consistent , easy and convenient to give detailed pattern
• Suitable for indoor and outdoor applications
• Preliminary preparation is very little or not at all.
• it is fast, unlimited color and size, stone or brick application can perform the same day.
• You create both the application and the patterns at the same time

Application lnstructions
Surfaces should be free from all kinds of dust, oil, dirt, rust, mold oil, detergent, ete. surfaces shouldbe smooth, weak parts should be removed. lfthere is cracks in t e floor orwall to be applied, it should be repaired with appropriate TEKNOREP repair mortars. in hot weather, it is recommended to apply TEKNOLATEX 400 as a primer before application. lf the application absorbent, then TEKNOLATEX 300 should be preferred as a primer surface is not TEKNOSER BASKI DUVAR is added slowly into clean and cold water and mixed with a low speed mixer for about ı O minutes until the mixture becomes lump free.

Mixed mortar has rested for 3 minutes and mixed again. The amount of water required must be adjusted according to the weather conditions. 25 kg TEKNOSER BASKI DUVAR, 4-5 liters of water mixed and then applied to the wall. The prepared mixture should be consumed within 30 minutes depending on the weather conditions. For mold press, the appropriate thickness of mortar should be applied to the surface at roughly the same level. After applying the appropriate mold separator to the press molds, it is placed on the wall surfaces with attention to the additional places. After the proper pressure process, the molds are carefully removed from the surface. Simple defects should be corrected with trowel ifthey exist on the surface.

Uygulama Notları / Sınırlamalar
• After application, it should be protected against adverse weather conditions such as direct sunlight, severe wind, high air temperature (above +35 °C) rain and frost. Cleaning can only done using mechanical equipment as the hardening will be completed a few days after the application.
Wash your hands with warm water and soap immediately after application.
• The product may cause sensitization by skin contact. Protective gloves or goggles should be worn and protective cream may be applied before work. in case of contact with eyes, rinse immediately with plenty of water and seek medical advice.