CATEGORIES
SHEETS CAN DOWNLOAD HERE TSE DOCUMENT
DID YOU SEE? CE DOCUMENT
DID YOU SEE? OUR CATALOG YOU CAN
DOWNLOAD AS PDF
- Tile Adhesives and Joint Fillers Fuga
- Repair Mortars and Grouts
- Thermal Insulation Products
- Industrial Flooring Products
- Granito Microbeton
- Tekno Stone Carpet
- Restoration Products
- Waterproofing Products
- Concrete Admixtures
- Construction Reinforcement Products
- Construction Chemicals General List
SHEETS CAN DOWNLOAD HERE TSE DOCUMENT
DID YOU SEE? CE DOCUMENT
DID YOU SEE? OUR CATALOG YOU CAN
DOWNLOAD AS PDF
Teknobond 250 Industrial PVC Floor Adhesive
Industrial PVC Floor Adhesive
TDS Technical Document Sheet
Acrylic-based, water-based, new generation PVC and linoleum floor covering adhesive with high-adhesion strength.
Areas of Usage
• Hospitals, laboratories, housing, shopping center,
• PVC, PU, latex backed flooring,
• Marley, marble, linoleum,
• Homogeneous and heterogeneous floor coverings,
• PVC, PU and latex coated applications,
• in flexible and woven insulated surface coatings,
• On ready-made flat and absorbent surfaces,
• For bonding carpet, PVC coated materials, concrete and shoe.
Features and Benefits
• Easy to apply.
• Long working range and high strength.
• Solvent-free
• it gives high performance in initial and final adhesion.
• it is suitableforfloor heating from the ground.
• it is resistant to wheel chair loads.
Application lnstructions
Surface quality: The surface of the application should be cleaned from materials which prevent adhesion such as dust, oil, tar, detergent and mold oil. Loose parts should be dismantled, cleaned with compressed air compressor orvacuum.
Surface Preparation: lf there are gaps, swelling and undulation on the floor, surface leveling should be done using TEKNOSELF or TEKNO-SELF 500. Priming with TEKNOLATEX 200 can be done if necessary according to the floor condition.
TEKNOBOND 250 is applied to the surface with a sawtooth trowel. The consumption is adjusted according to the tooth depth of the trowel. TEKNOBOND 250 is bonded to the PVC coating surface without forming the adhesive film layer within 2-3 minutes as it is applied to the surface. ünce adhesion is achieved, pressure is applied fora short period of time.
Application Notes / Restrictions
• The heating system for floor heating must be operated 1O days before the coating and should be closed during coating.
• The floor temperature should be between +18 and +25°C for optimum operation.
• The heater can be started again 72 hours after coating.
• The layer which may be formed on the surface during a long storage period should be discarded before use.
• Ali equipment used, immediately after application, not yet hardened; should be cleaned with hot water. The cured product can only be mechanically cleaned.
• Hands should be washed with warm water and soap.
• Eye contact should be avoided.