Tile Adhesives and Joint Fillers Fuga

  TDS Technical Document Sheet   

  TSE Document   

Product Description
Cement based joint filler for ceramics and tiles.

Areas of Usage
• lndoors,
• in horizontal and vertical joints,
• Tiles, ceramics , natural stone,
• Pressed brick, glass mosaic, granite,
• Suitablefor1 -6mmjointspacing.

Features and Benefits
• Easy to prepare and apply.
• Provides a smooth surface.
• it is abrasion resistant.
• it does not crack.
• Long workabilitytime.

Application lnstructions
Surface Preparation: Joints on floors coated with tiles, ceramic, natural stone, pressed bricks, glass mosaic, granite and other flooring materials should be cleaned thoroughly before application, removed from dust and wiped with a wet sponge.
Mixing: The material becomes ready for use only by adding water. 20 kg TEKNODER is poured into
6,0 lt water. The mixture is mixed with a slow speed drill until homogenous. When the prepared mixture reaches the desired consistency, it is rested for 5 minutes and mixed again. The mixture is applied to the surface by means of rubber trowel in horizontal and vertical applications.
Cleaning: it must be protected after application against adverse weather conditions such as direct sunlight, high air temperature (above+35°C), rain and frost. The product should be cleaned thoroughly with water and detergent before it is fully cured and hardened.

Application Notes / Restrictions
• Clean, clear water received from normal ambient temperature into a clean container which is free kinds of materials which prevent adhesion.
• The depth between the joints should be at least 2/3 of the ceramic thickness.
• TEKNODERZ in 20 kg bag as powder is poured into a container filled with water.
• The product is mixed with a low speed mixer until a homogeneous mixture without lumps is obtained.
• The mortar obtained at the end of the process should be rested for 5-10 minutes and mixed again until it becomes homogeneous for 1-2 minutes.