Waterproofing Products

  TDS Technical Document Sheet   

  CE Document   

Product Description
Teknomer 400 is a modified, bituminous and solvent based, one component, use is a ready to use bitumen solution. After evaporation of the solvent inside it, it strongly adheres to the surface where it is applied, forming a water resistant film layer.

Areas of Usage
• Retaining and curtain walls,
• Against floor humidty and leaking waters,
• On the reinforced concrete terrace,
• Against the rainy waters on the balconies and the hidden rivers,
• in the insulation of the gallery, drainage and waste water ducts and collectors,
• it is used in the isolation of open water for storage and against water and moisture in pools.
• The protection of metal surfaces (casting , sheet metal, ete.) against corrosion can be applied by immersion, spraying orspraying.
• it is used asa primer in bituminous membrane applications on metal surfaces.

Features and Benefits
• Ready to be applied.
• Must be applied cold, does not require heating and thinning.
• it will dryvery quickly.
• it forms an integral and continuous insulation layer.
• Crack bridge can be built.
• lt's very elastic.

Application lnstructions
The surfaces must be clean, smooth, solid, free from any antiadhesive substance such as dust, oil, dirt, rust, mold oil, detergent and waste. lf there is segregation in concrete, it should be discarded and loose parts should be removed, weak parts should be removed. lf there are cracks and cavities in the floor or wall to be applied, repair it with appropriate TEKNOREP repair mortar. Teknomer 400 should be applied after 3-4 days.

Surface Preparation: The surface to be insulated must be dry. Water puddles should be removed if there is pond watering. TEKNOMER 400 lf there is dilatation of the structure before applying the primer, isolation of the dilatation with TEKNOMER Champer Tapes and TEKNOBOND 400 D is necessary. Later isolation of dilatations is more difficult and costly.

Application Notes / Restrictions
• Foreign materials should not be added.
• it should not be applied under direct sunlight.
• it should be applied in two layers.
• it should not be applied in the rain.
• The product should not be diluted with water.
• Newly applied material is finished to cure, ete. until rain. it must be protected against weather conditions.
• Teknomer 400 is mixed in a clean container or in its own container, which is free from all sorts of obstruction-free materials. The product is mixed with a low speed mixer until a homogeneous mixture without lumps is obtained. Mixing time should be minimum 5 min.
• it must be protected after application against adverse weather conditions such as direct sunlight, high air temperature (above +35 °C), rain and frost. The product should be cleaned thoroughly with water and detergent before it is fully cured and hardened.
• lmmediately after application, before hardened, the equipment should be cleaned with TEKNO Thinner. Afterthe product is hardened, it should be cleaned by mechanical methods.
• The mixture is applied to the surface with finished, ready to use product, hard bristle brush or spraying machine. After the material completes the reaction, 2. coat application is made in the perpendicular direction of the first coat application. The waiting period between floors is at least 1 hour, and when there is no trace on the fingers in hand control after application of the first coat, it can be passed to the other floors. lf desired, it can be used as carrier glass fiber, reinforcement throughout the floors.
• Since the product does not have UV resistance, it is absolutely necessary to use heat insulation plates, protection plates, geotextile felt, should be covered with.