Waterproofing Products

  TDS Technical Document Sheet   

Product Description
Elastic, thermoplastic elastomer (TPE) based, polyester mesh carrier, 120/70 mm wide, elastic joint sealant used in the insulation of construction joints

Areas of Usage
• Under the tiles and ceramics in the interior,
• Prior to the application of tiles, ceramics and waterproofing in wet areas such as pools, water depots, bathrooms, WCs,
• in the details ofthe pipe entry-exit application such as watertank, pool,
• Wet spaces, balconies, between terraces of riding-based waterproofing materials,
• Between the floors of the ceramic adhesives,
• it is used forthe isolation of dynamic (moving) cracks and cold joints in floors and curtains.

Features and Benefits
• Provides reinforcing reinforcement using waterproofing materials based on sliding.
• it is easily cut and adhered by welding and it is easily applied in all kinds of water insulation details.
• Before concrete is poured, it is placed atthe planned place and afterthe concrete is hardened, it remains inside and provides water insulation.
• it is resistant to irreversible, crushing and bending.
• it is resistant to many chemicals.
• it is economical.

Application lnstructions
Surface Preparation: The application surface should be cleaned from all kinds of anti-adhesion materials such as dust, oil, paint, silicone, curing material, detergent.

Application Notes / Restrictions
• Waterproofing material should be selected in accordance with the application and environment conditions. lnsulation
• TEKNOMER Pah Bandi should be taken according to the place to be applied before the material is cut and stored readyfor application.
• TEKNOMER Pah Bandi is laid on the cold joint, corner and horizontal-vertical joints and dynamic cracks after the first layer of the sliding waterproofing material is applied. The first layer of insulation should be applied a little too much for the bach tape to be embedded into the waterproofing material.
• The bark tapes can be applied to ceramics, granite-ceramic adhesives, and concrete surfaces with acrylic adhesives. The ends of the joining of the bach band are heated with the source pod to PVC softener and then thetop ofthe min. 1O cm is pressed in thefutureto stickto each other.
• in this way a continuous and uninterrupted insulation is provided. After this, second layer of waterproofing material should be applied on the TEKNOMER Pah Bandi and the insulation should be completely covered.
• Make sure that the bevel band is completely covered after application. Do not approach the flame. lf the product is a fire jumble, wash it with water jet and do not apply the foam application. it is not recommended in environments where the temperature is high.
• it must be protected after application against adverse weather conditions such as direct sunlight, high air temperature (above +35 °C), rain and frost. The product should be cleaned thoroughly with water and detergent before it is fully cured and hardened.